A python module for handling realtime sensor data from OBD-II vehicle ports. It is derived from the python-OBD repo for serial data. This is an adaption for ELM327 Wifi compatible modules.

 Basic Usage ----------- ```Python import obd connection = obd.OBD("192.168.0.10", 35000) # connect to specific OBD-II-wifi Adapter. In our case it is a Panda by comma.ai cmd = obd.commands.SPEED # select an OBD command (sensor) response = connection.query(cmd) # send the command, and parse the response print(response.value) # returns unit-bearing values thanks to Pint print(response.value.to("mph")) # user-friendly unit conversions 

Available at python-obd.readthedocs.org

Here are a handful of the supported commands (sensors). For a full list, see the docs

note: support for these commands will vary from car to car

• Calculated Engine Load
• Engine Coolant Temperature
• Fuel Pressure
• Intake Manifold Pressure
• Engine RPM
• Vehicle Speed
• Timing Advance
• Intake Air Temp
• Air Flow Rate (MAF)
• Throttle Position
• Engine Run Time
• Fuel Level Input
• Number of warm-ups since codes cleared
• Barometric Pressure
• Ambient air temperature
• Commanded throttle actuator
• Time run with MIL on
• Time since trouble codes cleared
• Hybrid battery pack remaining life
• Engine fuel rate

GNU GPL v2

This library is forked from:

• https://github.com/peterh/pyobd
• https://github.com/Pbartek/pyobd-pi
• https://github.com/brendan-w/python-OBD

Enjoy and drive safe!